Paper Mâché Carousel - More on Creating the Column - Part 37

This week I have been working more on creating the central column.  I wanted to have some trim on the top and base of the column to give it some more gluing area and to cover the join between the base and ceiling platforms.  I went through a couple of changes on how I wanted to make it, but I think this change will make it work better.  At first, I envisioned the trim pieces as a separate piece, but I think it will work better as something made as an integral part of the column.  It will give me more gluing area when I attach it to the base.

I will show another picture of the column in a minute in a different photo.  But, for now, I will start with making the trim pieces.  I started by tracing around the column on a piece of cardboard.  That would be the inner circle.  

It is hard to see in the picture, but I made some registration marks on the inner circle and corresponding marks on the column.  These will make it easier to make it fit on the column.  Slight variations in the thickness of the paper mâché layers, and slight cutting errors make it harder to match up the column and trim without the registration marks.

I measured the diameter of the inner circle and marked the center.  Then I used a compass to draw the outer circle.  The registration marks were then transferred to the inside of the outer circle.  Then I cut out the inner circle and outer circle with a sharp craft knife.  

I made four of these circles.  The cardboard was not thick enough in a single layer, of I used two circles taped together to form a single layer to make it as thick as I wanted.  The registration marks were remarked on each layer of the tape.

In the upper portion of this photo, the base of the column is shown with the first set of rings taped to it.  

The column and rings matched up easily when using the registration marks.  The column of the cylinder was made using a repurposed oatmeal container.  Scroll back to previous posts to see that being covered in paper mâché.  If you cannot scroll back, you can go to this blog's URL which is folkartbycaroljones.blogspot.com  

So here is the column with both sets of the trim attached.  Each end is double taped to make prevent water infiltration into the cardboard from the paper mâché paste.  I always double tape because I have had some unfortunate experiences in previous projects when the paste was too moist and the carboard soaked it up.  

The angle used when taking the photo makes it look as if the top trim is larger than the base.  That is just a property of the photo.  The trim pieces are actually the same size top and bottom.

There are a couple of places that are not exactly in the round due to small cutting errors.  They can be built up later with layers of paper mâché strips.  The areas are so small that it was not worth the effort of cutting out two more circles.  When the carousel is finished, it won't even be noticeable.

I just added a picture of the carousel that I took when I was testing the rotating mechanism.  It gives you an idea of what I am shooting for with the central column.  

This coming week I will be working on the paper mâché layers that will make the trim a permanent part of the column.  Maybe I will have a chance to at least get the primer coat on it.

Anyway, that is my stopping point for this week.  I am getting very excited.  Now that I have all the major pieces ready, I can start decorating and painting the animals.  I want to add saddles, bridles, flowers, and ribbons to the animals using paper mâché clay.  I will probably be making the clay myself, so stay tuned for more information on that part of the project.  

Check back next Monday or Tuesday for the next blog post.